LMI固件损坏恢复方案

Use the following steps to recover from bad firmware:

• Power off the device
• Make sure the device is directly connected to the PC – don't use a switch
• Configure the PC as to use IP-address: 192.168.1.1 and netmask: 255.255.0.0
• Start the kRescue application bin\win32\kRescue.exe
• Power on the device
• Close the kRescue application
• Open a browser and point it to http://192.168.1.10
• Apply an upgrade package that is known to work
  

啥意思呢？
就是关机后确保直接通过网线连接LMI设备，然后配置PC端的IP为192.168.1.1 子网掩码为255.255.0.0，然后启动位于bin\win32\kRescue.exe下面的kRescue应用程序，然后再次打开设备，关闭kRescue，打开浏览器输入地址http://192.168.1.10，然后上传一个可以正常工作的更新包即可！