create_metrology_modelT_create_metrology_modelCreateMetrologyModelCreateMetrologyModelcreate_metrology_model (算子名称)

名称

create_metrology_modelT_create_metrology_modelCreateMetrologyModelCreateMetrologyModelcreate_metrology_model — Create the data structure that is needed to measure geometric shapes.

参数签名

描述

create_metrology_modelcreate_metrology_modelCreateMetrologyModelCreateMetrologyModelCreateMetrologyModelcreate_metrology_model creates a metrology model, i.e., the data structure that is needed to measure objects with a specific geometric shape (metrology object) via 2D metrology, and returns it in the handle MetrologyHandleMetrologyHandleMetrologyHandleMetrologyHandlemetrologyHandlemetrology_handle.

For an explanation of the concept of 2D metrology see the introduction of chapter 2D Metrology.

注意

Note, that after calling the operator create_metrology_modelcreate_metrology_modelCreateMetrologyModelCreateMetrologyModelCreateMetrologyModelcreate_metrology_model the operator set_metrology_model_image_sizeset_metrology_model_image_sizeSetMetrologyModelImageSizeSetMetrologyModelImageSizeSetMetrologyModelImageSizeset_metrology_model_image_size should be called for efficiency reasons.

运行信息

• Multithreading type: reentrant (runs in parallel with non-exclusive operators).
• Multithreading scope: global (may be called from any thread).
• Processed without parallelization.

This operator returns a handle. Note that the state of an instance of this handle type may be changed by specific operators even though the handle is used as an input parameter by those operators.

参数表

例程 (HDevelop)

read_image (Image, 'fabrik')
create_metrology_model (MetrologyHandle)
get_image_size (Image, Width, Height)
set_metrology_model_image_size (MetrologyHandle, Width, Height)
add_metrology_object_rectangle2_measure (MetrologyHandle, 270, 230, 0, 30, \
                                  25, 10, 2, 1, 30, [], [], Index)
apply_metrology_model (Image, MetrologyHandle)
get_metrology_object_result (MetrologyHandle, Index, 'all', 'result_type', \
                      'all_param', Rectangle)
get_metrology_object_result_contour (Contour, MetrologyHandle, \
                                    Index, 'all', 1.5)

结果

If the parameters are valid, the operator create_metrology_modelcreate_metrology_modelCreateMetrologyModelCreateMetrologyModelCreateMetrologyModelcreate_metrology_model returns the value 2 ( H_MSG_TRUE) . If necessary, an exception is raised.

可能的后置算子

set_metrology_model_image_sizeset_metrology_model_image_sizeSetMetrologyModelImageSizeSetMetrologyModelImageSizeSetMetrologyModelImageSizeset_metrology_model_image_size

模块

2D Metrology